Skookum uus tarkvara on väljas, rev 3.12
Posted: Sat Aug 11, 2012 22:10
http://www.helifreak.com/showthread.php?t=443081
Hi All,
Having a little trouble with the website this morning, but for the keeners, here's the link:
http://www.skookumrobotics.com/downl...ler_Rev312.zip
Updates include:
Setup Software Rev 3.12
* The re-level accel function is more reliable and gives a confirmation message
* Minor tweaks
SK720 firmware rev 3.12
* Fixed a bug where it would sometimes reset if logging was turned on.
SK540 firmware rev 3.12
* Fixed a problem with tail drift some users were having.
Both the SK720 and SK540, rev 3.12
* Slight re-scaling of the aux output channels for PPM (Robbe single-wire rx's)
* An DMSS mode is added for the XG7. Sadly the XG11 still isn't working (JR implemented each of their DMSS radios differently). We're hoping to get it in for the next update.
* Tweaks to the governor
SK-LCD Rev 3.12
* Added DMSS XG7 mode to receiver list
* Fixed a bug where self-level would not allow more than 100% gain
* Fixed a bug where going to the "Actual gains" page would reset the unit.
Coming Soon: An update to support the SK-GPS unit, misc other upgrades, and 3D performance improvements. We're now oversupplied with a large number pretty paperweights, so our motivation to get this one finished is high!
Skookum Robotics
Hi All,
Having a little trouble with the website this morning, but for the keeners, here's the link:
http://www.skookumrobotics.com/downl...ler_Rev312.zip
Updates include:
Setup Software Rev 3.12
* The re-level accel function is more reliable and gives a confirmation message
* Minor tweaks
SK720 firmware rev 3.12
* Fixed a bug where it would sometimes reset if logging was turned on.
SK540 firmware rev 3.12
* Fixed a problem with tail drift some users were having.
Both the SK720 and SK540, rev 3.12
* Slight re-scaling of the aux output channels for PPM (Robbe single-wire rx's)
* An DMSS mode is added for the XG7. Sadly the XG11 still isn't working (JR implemented each of their DMSS radios differently). We're hoping to get it in for the next update.
* Tweaks to the governor
SK-LCD Rev 3.12
* Added DMSS XG7 mode to receiver list
* Fixed a bug where self-level would not allow more than 100% gain
* Fixed a bug where going to the "Actual gains" page would reset the unit.
Coming Soon: An update to support the SK-GPS unit, misc other upgrades, and 3D performance improvements. We're now oversupplied with a large number pretty paperweights, so our motivation to get this one finished is high!
Skookum Robotics