M: X-Power 601BC Digital Multifunctional Charger/Discharger

[vana]

PC balanzerlaadija/mahalaadija paljude funktsioonidega, USB sisendiga, näitab LiPo laadimisel iga purgi pinget eraldi, Delta piik valitav, jne, jne.
Max võimsus 50W, laadimine kuni 5A, 2A maha, 5x tsükkel.....

Microprocessor controlled high-performance rapid charger/discharger for NiCd/ NiMH / Li-polymer/ Pb batteries
USB communicated analysis and separate voltage detector
Charge current up to 5A,discharge current up to 2 A,5 battery memoried.1~5 series Li-ion/pol,1~12 cells NiCd/NiMh,6 and 12V lead-acid(Pb).
Optimized operating software
The charging system has an ‘Auto’ function to set the current automatically. Especially for Lithium batteries. It can prevent from over-charging can lead to an explosion by users fault. Every program in the unit is controlled with mutual links and communicates for every possible error so it introduces a maximum safety. These can be set at users option.
Maximum safety
Delta-peak sensitivity: The automatic charge termination program works on the principle of the Delta-peak voltage detection. The charge monitors the voltage of the charging current and time. If the charging capacity exceeds the limit the process will be terminated automatically when you set the maximum value.
Processing time limit: you can also restrain the maximum process time to prevent from any possible defect.
Input power monitor: To protect the car battery using as input power from being damaged the voltage of it always monitored. If it drops below the lower limit the process will be ended automatically.
Monitoring the voltage of individual cell
Unbalance of voltage of each cell can occur in the Lithium battery pack because of consecutive charge and discharge. Using ‘Balance-guard’ the charger monitors the voltage of each cell and controls the charge and discharge current to equalize the voltage. For this process the charger communicates with external balance-guard by the Data store / load.
For users convenience it can store maximum 10 data of different batteries. You can establish the data contains program setting of the battery to be charged or discharged continually. These data can be called out at any time you need and the process will be executed without program setting.
Cyclic charging /discharging
Perform 1 to 5 cycles of charge -> discharge or discharge -> charge continually for battery refreshing and balancing.
Specification:

Li-ion Polymer Battery : 1 - 5 series
Ni-MH / Ni-Cd Battery : 1 - 14 cells
Lead Acid (PD) : 6 - 12V
Charge / Discharge Cycle : 1 - 5
Charging Rate : 0.1A - 5.0A
Discharger Rate : 0.1A - 2A
Battery Memory : 10 models
Weight : 342g
Dimensions : 130 x 88 x 26mm
Item(s) Included:

X-Power 601BC Digital Multifunctional Charger / Discharger
USB PC Link
AC-DC adopter (110v/220-240v avaliable)
Multifuctional battery connector

KÕIK SEE kraam 900.-EEK´i